Rent Temporary Wacker Neuson E1100 Ground Heater Generator Rental

Engineered for reliable performance and trouble-free starts for up to 140 hours of run time, the E1100 will provide maximum flow and ensure consistent heat delivery for thawing and curing applications. The E1100 thaws or cures up to 2200 sq. ft. The E1100 will also set, finish and cure 2,200 sq. ft. of concrete; up to 6,600 sq. ft. with accessories. At 85% efficiency, the E1100 offers the highest in the industry.

---

Wacker Neuson E1100 Ground Heater Features

Heater gross output 126,000 BTU/H
Heater net output 110,000 BTU/H
Heater efficiency 87 percent 
Temperature con1roller digital
Fuel consumption at full load .90/1.32 US GPH
Fuel requirement winter blend diesel
Run time up to 115 hours
Electrical requirement 1 x 20 amps x 120V AC
Normal operating temp 100°F - 180°F
Normal hose operating pressure 70 - 90 psi
HTF flow rate per loop 265 US GPH
Thawing capacity (standard) 1, 100 - 2,200 sq. ft.
Thawing capacity (w/accessories) 2,200 - 3,300 sq. ft.
Curing capacity (standard) 2, 2 00 sq. ft.
Curing capacity (w/accessories) up to 6,600 sq. ft.
Frost prevention (standard) up to 3,300 sq. ft.
Frost prevention (with accessories) up1 to 9,900 sq. ft.
Air heat capacity (with accessories) 180,000 cu ft.
Performance monitoring light yes 
​

Length hitch assembly extended 114
Length hitch assembly folded 88
Width 65”
Height 61”
Ground clearance 1 
Weight w/ fuel 1,992 lbs. /2,252 lbs.
Weight with fuel 2,456 lbs. /2,716 lbs.
Fuel capacity 72 US GAL
Heat Transfer Fluid 50 US GAL
Pump 265 US GPH positive displacement
Hose 1,100 ft.
Hose reel 1
Hose rewind 120V AC, w/ 12V DC clutch
Circulation Loop 1
Tires ST185/80D 13
Hitch 2 ball
Lifting bar yes
Fork lift pockets both rear and side

BACK TO EQUIPMENT PAGE

Wacker Neuson E1100 Ground HeaterSpecifications

Brochure​

With 1,100 ft. of hose and a hydraulic hose system, the E1100 allows for single person set-up and placement, for greater flexibility on all applications.
Positive displacement pump provides maximum flow and consistent heat delivery for thawing and curing. One pump per hose loop means delivery of maximum Btu's per hour. Digital temperature controller with push button adjustment allows operators to easily adjust Heat Transfer Fluid (HTF) output temperature for all concrete curing applications. Performance monitoring strobe light indicates from a distance that all systems are operating properly. Low power requirements: operates from a single 115V, 20 Amp outlet. Options include a 3.5 kW air cooled diesel generator with sound attenuated enclosure and on-board load management system to prevent wet stacking.